Cabinet Checklist, Take One

Okay, gotta make myself a checklist so I can finish this project up in a reasonable amount of time.  It looks like a lot, but I can usually take out a number of these in a day.

Did I mention that a MAME cabinet requires a huge amount of commitment?  ;)

Stage One: Construction

• Round cabinet corner sides (optional).
• Attach 2x4's to sides of cabinet for all edges, monitor and speaker/marquee shelves.
• Construct strong monitor shelf from already-cut wood and 2x4's.
• Attach cabinet sides to base, using 2x4s to connect sides together.
• Install cabinet front using Blum hinges and key lock.
• Install cabinet back with Blum hinges and key lock.
• Cut 45-degree angles on cabinet back diagonal piece.
• Install cabinet top and back diagonal piece.
• Cut T-moulding groove with router and slot-cutting bit.
• Install T-moulding.
• Cut 45-degree angle for control panel back.
• Assemble control panel, using blum hinges and draw hasp for top.
• Install drawer slides in cabinet and control panel, attach control panel to cabinet.

Stage Two: Installation/Wiring

• Purchase 25" or 27" inch TV (possibly Sony Wega).
• Order buttons, joysticks, coin box, marquee light, marquee retainer from Happ Controls.
• Order Opti-Pac, i-Pac, joysticks and trackball from Ultimarc.
• Order spinners and spinner tops from Oscar Controls.
• Cut coin box hole in cabinet front.
• Install coin box.
• Drill speaker holes above display.
• Drill control and joystick holes in cabinet top.
• Test-install all controls, make sure everything is correct, remove controls.
• Sand, prime and paint all cabinet surfaces.
• Re-install controls.
• Wire all controls to i-Pac and Opti-Pac, test controls.
• Install TV on monitor shelf, secure.
• Construct paper bezel for TV (from arcadecontrols.org forum instructions).
• Install plexiglass (tinted and clear?) in front of TV.
• Install speakers in speaker holes.
• Install light behind marquee.
• Install marquee with marquee retainer.
• Install extra speakers, if needed.
• Install subwoofer in cabinet base.

Stage Three: Computer Hardware/Software

• Mount motherboard in cabinet by mounting in slotted 2x2 pieces of wood.
• Mount power-supply to cabinet interior.
• Mount harddrive and enclosure within cabinet.
• Install additional ventilation- top and back of cabinet.
• Install 4-port home-connect-style multimedia ports with ethernet jack in rear of cabinet (any other wiring?).
• Drill/cut hole for single external power cord.
• Install Fedora Core 2.
• Install MAME packages.
• Test-play system for kicks.  ;)
• Set-up front end and fancy boot process.
• ... ?
• PROFIT!